The Experimental Procedure of Crushing Plant Cells with Ultrasonic Crushing Processor | Ultrasonic Disperser | Probe Sonicator
(1) Boot
Insert the power supply, insert the power output port connector, and connect it with the transducer. Press the power button. At this time, the digital tube of each display window will be lit up and all the buttons will be activated.
(2) Adjust the number of cycles
Push the cycle number, number of cycle time digital display window ten digits start flashing, press the plus or minus key, to the required number, then press cycle, cycle time window display number bits start flashing, press the plus or minus key required Numbers, again press cycles, adjust the number was confirmed, the mill began to work, stop after the cycle number, at the same time a sound told that work is over.
(3) Work time and gap time adjustment
Press the corresponding keys for working time setting and clearance time setting to adjust the working time and clearance time, as shown in the above steps, unit time: seconds.
(4) Adjust the power gear
Press the button "increase" or "decrease" to change the number of power display window from 0 to 5, with the minimum power at 0 and the maximum power at 5.
(5) Start
After the above adjustment, press the start button to start the work. If no vibration is issued, adjust according to the following method.
(6) Adjust power
Press the above button to connect the frequency table, press the tuning power button, and press the start button to start the machine. At this time, insert the screwdriver into the tuning hole, and slowly twist it in the clockwise and counterclockwise directions, adjust the frequency to the frequency modulation of the amplitude transformer, and send out strong vibration until.
(7) Continuous, stop key
Press the button for continuous work, and press the button for stopping work halfway.
Ultrasonic Processor | Sonicator | Homogenizer in BuenoBiotech